Miniature Step and Directional Driver
<<Return to previous page
2 Phase Unipolar Stepper Motor Drivers
2 Phase Bipolar Stepper Motor Drivers
3 Phase Stepper Motor Drivers
5 Phase Stepper Motor Drivers
Miniature Stepper Motor Drivers
 
How to select the right motor driver & much more... Motor driver applications
  <<Return to previous page     <<Return to HOME Page
 Miniature Step and Directional Driver
 Check to see which best fit your needs. If you have any questions, please call for assistance at 1-800-790-7837 or e-mail sales@netmotion.com
ALLMotion EZINCH
 
Data Sheet Wiring Diagram
     1Amp Stepper Motor Drive measuring  only 1" x 1"
  • 12V - 30V  1Amp
  • 1" x 1" Size
  • Eighth Step

Measuring just 1" X 1" , the EZ Inch Stepper Driver was designed to allow users to create miniature motion control solutions.

The inputs to this drive are STEP, DIRECTION, POWER (12V-30V) and GROUND. (There is no requirement for separate 5V power). The step and direction inputs accept 5V TTL level signals, or can accept switch closures to ground.  Please see the Wiring Diagram .

Two on board potentiometers set the MOVE and HOLD currents, and the on board electronics automatically switch between the two current settings when pulses are detected on the STEP input.

The drive current is up to 1Amp.

EZINCH Features
  • 4 Wire input STEP,DIRECTION,GROUND,POWER
  • 1 Amp Chopper (PWM) Stepper Driver.
  • MilliOhm FETs allow board to run cool at 100% current.
  • Operates from 12V to 30V.
  • 1" X 1" X 0.5" Thick
  • Eighth,Quarter,Half, or Full Step - Dip Switch Selectable.
  • Hold and Move current settable with Potentiometers.
  • Move current automatically selected when step input is active.
  • Hold current automatically selected upon move completion.
  • Upto 25000 pulses per second.
Data Sheet Wiring Diagram
 
TOP of the PAGE
Click below to request for a quotation:
   
For further information, please contact NetMotion, Inc. at 1.800.790.7837 or 510.578.2811 or e-mail sales@netmotion.com
Copyright © 2003 NetMotion, Inc.